Aeration cooling can save moist grain

December 7 2021 - 11:00pm
GRDC national grain storage extension project co-ordinator Chris Warrick.

WITH substantial yields expected across much of the grain growing area and wet weather having hampered harvesting efforts, growers are being encouraged to consider how they will manage onfarm storage to preserve grain quality.

Storing cereals and pulses with an average moisture content above 12.5 per cent can cause a range of issues, including mould and insect outbreaks in storage facilities.

Advertisement

Ad

Grains Research and Development Corporation (GRDC) national grain storage extension project co-ordinator Chris Warrick said aeration cooling could play a critical role in successful onfarm storage this season.

"Aeration cooling allows grain that was harvested slightly over-moisture to be stored for up to three to four weeks before it is dried or blended with dry loads," Mr Warrick said.

Recent survey data revealed that aeration cooling is widely under-utilised in Australian onfarm grain storage, with two thirds of growers not using it, not realising it can be retro-fitted to their existing silos or not ordering it as part of new storage capacity.

Mixing over-moist grain with drier loads will lead to a lower average moisture once the two loads are properly blended.

"Ideally, the blended load will be put back into storage with aeration cooling to help redistribute moisture evenly among the grain," Mr Warrick said.

"The cooling fans need to be run continuously if the grain has a moisture content above 12.5pc, unless the ambient relative humidity is above 85pc for an extended period.

"Even air distribution through the silo and open lids or vents are essential, as is monitoring the grain temperature daily.

"The fans must deliver at least two litres of air per second per tonne of grain just to hold over-moist grain safely.

"Drying grain out requires much higher airflows, in excess of 15L/s/t, which is only possible with high capacity systems specifically designed for aeration drying."

Mr Warrick said grain drying facilities had the benefit of being able to dry grain down to a safe moisture content for storage but are different systems to aeration cooling, which is important to understand.

Aeration cooling can enable over-moisture grain to be held temporarily until it can be dried or blended.

The longer-term benefits of aeration cooling are preserving grain quality including germination characteristics, grain colour in pulses and creating unwelcoming conditions for mould and insects.

Mr Warrick said the most common cooling mistake was not running the fans for enough hours to thoroughly cool the entire silo and push fresh cooling air right through the silo.

That could result in grain at the top of the silo remaining warm.

Grain that has been harvested, dried or blended below 12.5pc moisture content can be managed with a three-step cooling process.

  • Cooling fans should be run continuously from as soon as the aeration ducts are covered until three to five days after the silo is filled, or until the air coming out the top of the silo smells clean and fresh.
  • They should then be run for the 12 coolest hours of the next five to seven days and then for the 100 coolest hours of each subsequent month.
  • To optimise this process an automated aeration controller is recommended.

Want weekly news highlights delivered to your inbox? Sign up to the Farm Weekly newsletter.

Advertisement

Ad

Get the latest Western Australia news in your inbox

Sign up for our newsletter to stay up to date.

We care about the protection of your data. Read our Privacy Policy.